Hello friends...........
An advanced happy Christmas wishes to all. Today here I am showing everyone a simple tutorial to make a different LED xmas star. I hope for you also this will be a different experice and sure you are not seen this type of led xmas star before anywhere.
It's very simple to make and at the same time a variety product. Two main items needed to make this star is
- Chip Board
- RBG pixel led (Individually addressable)
- RGB Led controller
You can program the Led strip using Adruino or you can buy an RGB led strip controller in low cost.
First you have to cut the shape of your start in a chip board or any kind of sheet that us convenient to you. A chip board is easy to cut.
Second you can stick a 2 cm wide woos reaper or any material vertically on the back side of your start that you already cut.
Connect the LED to the controller and then give power supply. You will get a stunning output
If you need any more clarification, please look on the video I attached below. Also, you can comment your queries. Please check the video to get the complete running combination of star
